Vol.15,

This paper tries to outline the influence of atomic mobility on the initial fabrication of thin films formed by LECBD. Based on our recent studies on low-energy cluster beam deposition (LECBD) by molecular dynamics simulation, two examples, the deposition of small carbon clusters on Si and diamond surfaces and Al clusters on Ni substrate, were mainly discussed. The impact energy of the cluster ranges from 0.1 eV to 100 eV. In the former case, the mobility and the lateral migration of surface atoms, especially the recoil atoms, are enhanced with increasing the impact energy, which promote the film to be smoother and denser. For the latter case, the transverse kinetic energy of cluster atoms, caused mainly by the collision between moving cluster atoms, dominates the lateral spread of cluster atoms on the surface, which is contributive to layer-by-layer growth of thin films. Our result is consistent with the experimental observations that the film structure is strongly dependent on the impact energy. In addition, it elucidates that the atomic mobility takes a leading role in the structure characteristic of films formed by LECBD.

330

Based on a new second-order neutron transport equation, self-adjoint angular flux (SAAF) equation, the spherical harmonics (P_N) method for neutron transport equation on unstructured-meshes is derived. The spherical harmonics function is used to expand the angular flux. A set of differential equations about the spatial variable, which are coupled with each other, can be obtained. They are solved iteratively by using the finite element method on unstructured-meshes. A two-dimension transport calculation program is coded according to the model. The numerical results of some benchmark problems demonstrate that this method can give high precision results and avoid the ray effect very well.

362

The sputtering yield angular distributions have been calculated based on the ion energy dependence of total sputtering yields for Ni and Mo targets bombarded by low-energy Hg⁺ ion. The calculated curves show excellent agreement with the corresponding Wehner's experimental results of sputtering yield angular distribution. The fact clearly demonstrated the intrinsic relation between the ion energy dependence of total sputtering yields and the sputtering yield angular distribution. This intrinsic relation had been ignored in Yamamura's papers (1981,1982) due to some obvious mistakes.

335

546

The oxide contents of TiO₂, MnO, SrO and Fe₂O₃ in the body and graze layers of the Jiao-Tan-Xia (JTX) and Lao-Hu-Dong (LHD) porcelains in Southern Song Dynasty (1127-1279 A.D.) have been determined using an International Eagle-II μ-probe EDXRF spectrometer. The results show that the contents in the body are much different from those in the graze one. Therefore, the transient thickness (TT) between the body and graze layers can be measured through determination of a distance of the drift change in the chemical contents. The TT average for the JTX porcelains is 161μm, while that for the LHD porcelains is 258μm, which are consistent with a range of 0.15-0.3mm in the Ru-Yao porcelains. The different TT is related to the variances in firing temperature and raw material for manufacturing the respective porcelains.

471

In order to research multi-component ion beam transport process and improve transport efficiency, a special simulating program for ECR beam is becoming more and more necessary. We have developed a program written by Visual Basic to be dedicated to numerical simulation of the highly charged ion beam and to optimization of beam dynamics in transport line. In the program the exchange of electrons between highly charged ions and low charged ions or neutral atoms (residual gas in transport line) is taken into account, adopting classical molecular over-barrier model and Monte Carlo method, so the code can easily give the change of charge state distribution along the transmission line. The main advantage of the code is the ability to simultaneously simulate a large quantity of ions with different masses and charge states, and particularly, to simulate the loss of highly charged ions and the increase of low charged ions due to electron exchange in the whole transport process. Some simulations have been done to study the transmission line of LECR3^[1] which is an ECR ion source for highly charged ion beam at IMP. Compared with experimental results, the simulations are considered to be successful.

327

A cellular survival model and the cross section calculation with low and high LET for ion irradiation were presented. Based on our formula of surviving fraction calculation, the survival data of Chinese hamster cell (V-79 ) for ion irradiation including He, Li, B, C, O, Ne and Ar were calculated; the cross sections for ion irradiation including He, Ni, C, Ar, Kr, Xe and U were shown. The calculated results show that the presented model is a good description of radiation effects of V-79 cell for different ion irradiation. In this model splitting energy between ion-kill mode and gamma-kill model is avoided, the calculated results of cross section needn't be multiplied by a factor to fit the experimental data.

443

It is important to assess image quality, in order to ensure that the imaging system is performing optimally and also identify the weak points in an imaging system. Three parameters mostly leading to image degradation are contrast, spatial resolution and noise. There is always a trade-off between spatial resolution and signal to noise ratio, but in scintillating fiber array detectors spatial resolution is not as important as signal to noise ratio, so we paid more attention to contrast and SNR of the system. By using GEANT4 Monte Carlo detector simulation toolkit, some effective parameters of the linear plastic scintillating fiber (PSF) array as an imaging detector were investigated. Finally we show that it is possible to use this kind of detector to take CT and DR (Digital Radiography) image under certain conditions.

547

A new image reconstruction method was developed for a Compton camera. A simulation to determine a γ-ray source position was performed by using the simulation tool, GEANT4. An image reconstruction was made in two steps. First, a three dimensional image was constructed and projected in one selected plane, then the points from each ellipse was picked up by taking the peak points of a density distribution of crossing points between the ellipse and the first step image. The second step procedure improved the accuracy and the spatial resolution of a position determination significantly, comparing with the image obtained by only the first step. The accuracy and the resolution for a point source were obtained to be about 0.02 mm and (1.35±0.15) mm, respectively. The same procedure was applied to an imaging of the distributed γ-ray source.

334

The activation of gold by environmental neutrons through the reaction ¹⁹⁷Au (n,γ) ¹⁹⁸Au was used to study the effect of concrete buildings on the neutron flux, and to estimate the thermal neutron flux inside and outside these buildings. The results showed that three ceilings of thickness 34 g/cm² decrease the fast neutrons to 26% from its original value. However, the same reinforced concrete decreases the slow neturon flux to only 62% of its original value. The thermal neutron flux at 283 m from the center of training Reactor of Kinki University, was twice higher than the environmental neutron background.

411

The cold neutron source (CNS) is a facility to increase cold neutrons by scattering thermal neutrons in liquid hydrogen or deuterium around 20 K. For extracting a stable cold neutron flux from the CNS, the liquid quantity in the moderator cell should be maintained stably against disturbance of nuclear heating. The China Institute of Atomic Energy (CIAE) is now constructing the China Advanced Research Reactor (CARR: 60 MW), and designing the CARR-CNS with a two-phase thermo-siphon loop consisting of a condenser, two moderator transfer tubes and an annular cylindrical moderator cell. The mock-up tests were carried out using a full-scale loop with Freon-113, for validating the self-regulating characteristics of the loop, the void fraction less than 20% in the liquid hydrogen of the moderator cell, and the requirements for establishing the condition under which the inner shell has only vapor. The density ratio of liquid to vapor and the volumetric evaporation rate due to heat load are kept the same as those in normal operation of the CARR-CNS. The results show that the loop has the self-regulating characteristics and the inner shell contains only vapor, while the outer shell liquid. The local void fraction in the liquid increases with increasing of the loop pressure.

300